 |
 |
 |
 |
 |
CPVA REMOTE-VISUAL- ALARM
DESCRIPTION
The CPVA is a remote visual alarm for use with all Fluid Electronics' Control Panels. Remote visual alarms are typically used to warn of alarm conditions in locations other than where the main control panel is installed. In addition, they are used in locations where the background noise levels may be too great for the operator to hear the on-board alarm of the control panel. Typical uses for remote visual alarms are overfill prevention, low fuel levels, oil pump out for oil/water separators, etc.
SPECIFICATIONS
Housing Material
Steel, 16 gauge
Coating Type
Epoxy Powder Coat
Beacon Setting
65 Flashes per Minute
Beacon Color
RED
Terminal Block
3 inputs
Conduit Knockout
(1) 1/2" NPT
Installation
Wall Mount, 4 x #8 wood screws
Housing Dimensions
6" W x 6" H x 4" D
Housing w/ Beacon
6" W x 12-1/2" H x 4" D
Voltage
120 VAC ( ± 10%, 60 Hz)
AMPS
0.1
VA
12, 8.5 Watts
CPAA REMOTE-VISUAL- ALARM
DESCRIPTION
The CPAA is a remote audible alarm for use with all Fluid Electronics' Control Panels. Remote audible alarms are typically used to warn of alarm conditions in locations other than where the main control panel is installed. In addition, they are used in locations where the background noise levels may be too great for the operator to hear the on-board alarm of the control panel. Typical uses for remote audible alarms are overfill prevention, low fuel levels, oil pump out for oil/water separators, etc.
SPECIFICATIONS
Housing Material
Die-cast aluminum, 2-half shells
Coating Type
Industrial Gray, corrosion resistant epoxy
Horn Setting
78 to 103 dB @ 10 feet
Terminal Block
2 positions
Conduit Knockout
(1) 3/4" NPT
Installation
Wall Mount, 3 x #8 wood screws
Dimensions
4-7/8" W x 4-7/8" H x 3-5/16" D
Voltage
120 VAC (-20%, +10%, 60 Hz)
AMPS
0.13
VA
15.6, 11 Watts
For further information on Electronic Monitoring Equipment, navigate to any of the areas below.
Electronics Section Navigation:
 |
|
 |
|
 |
|
 |